induction curing ceramic fiber

Objective To heat-cure a NextelTM Ceramic fiberMaterial Ceramic fiber 30,000 (9,145) ft(m) Steel tubeTemperature indicating paintTemperature 1300(700) F(C)Frequency 70 kHzEquipment Power of 45kW, 50-450 kHz solid-state induction power supply with a remote …

induction curing measuring tape paint

Objective To heat measuring tape stock at a maximum rate of 600 feet per minute to cure the applied paint. The heating coil is to accommodate the 3/8″ wide stock within the customer’s current framework. Curing must occur above 400F at the rate specified.…

induction bonding solar panels

Objective To heat the stainless steel substrate of a solar panel shingle in order to melt the polymer encapsulant, allowing two shingles to bond together with a 3 inch overlap. Material 3″ by 10.25″ section of a 21″ solar panel shingle Temperature 130…

induction bonding steel clips

Objective To heat metal clips and press-bond them into rubber seals. The metal needs to be heated to 250F to 350F with a cycle time not exceeding 3 seconds Material Steel clips and rubber sealer blocks Temperature 250F to 350F Frequency 373 kHz Equipme…

metal to plastic by induction bonding

Objective To heat a steel magnetic steel post to 300F for a bonding application.Material Magnetic steel posts Plastic handleTemperature indicating paintTemperature 300F (149C)Frequency 288 kHzEquipment Power of 6 kW, 100-400 kHz induction heating power sup…

induction annealing stress relieving

STRESS RELIEVING,NORMALISING AND ANNEALINGStress RelievingStress relieving is applied to both ferrous and non-ferrous alloys and is intended to remove internal residual stresses generated by prior manufacturing processes such as machining, cold rolling and…

induction hardening and flame hardening

WHAT ARE THE TREATMENTS? Induction hardening and flame hardening are methods for hardening the surfaces of components, usually in selected areas, by the short-time application of high-intensity heating followed by quenching. The heating and hardening eff…

induction hardening and tempering of tools

WHAT ARE THE STEELS?Tool and die steels are covered in BS 4659:1989, although both American nomenclature and a variety oftrade names are also in use. Available in high-quality grades, these specifically-designed steels can be groupedbroadly according to t…

induction de-bonding stainless steel

Objective To separate bonded stainless steel / carbon fiber assemblies by heating tang, softening the adhesive bond Material Stainless steel and carbon fiber inserts Temperature 300 F (149C) Frequency 200 kHz Equipment • Power of 6kW induction heating…

induction bonding plastic sleeve to stainless steel handle

Objective Heating end of a stainless steel handle with a plastic sleeve coated with heat adhesive for a bonding applicationMaterial 1” (25mm) OD stainless steel handle 0.30” (7.6) thick covered with a plastic sleeve that is coated with a heat adhesive be…